Humax Freesat Setup

This article will guide you through the setup process on a Humax Freesat.

Firstly, please Login to our website, from your computer and take note of the fastest DNS server address that appears on screen.

On your device:

1. Press MENU on your Freesat remote control.
2. Go to SYSTEM
3. Choose NETWORK
6. Choose MANUAL
7. Navigate down to DNS ADDRESS and  enter the DNS server addresses that appeared on your browser earlier. Do not alter any of the other settings.
8. Press apply, then reboot the Freesat receiver.
9. Once you have done that, go back to your Simple Telly's account page and click on Check My Setup.

If this is the first device you have setup from this location, you will probably need to register your current IP address. Click on Register your new IP address.

You will get Everything's OK! message on your screen if your IP has been registered successfully in our system.

Now that you have setup and registered your system you can go ahead and access the TV site of your choice and stream it like you mean it!

If you would like any further assistance, please send us an email to and we will do our best to assist you.

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us