DNS Set up for Windows Vista

Setting up our service on a Windows Vista computer is very similar to setting this up on a Windows 7 machine, but just in case if the Windows 7 instructions is slightly different, you can refer to the instructions here:

Firstly, please Login to our website, www.simpletelly.com from your computer and take note of the fastest DNS server address that appears on screen.

Step 1: Click 'START' and open 'Control Panel'.

Step 2: Under the Network and Internet group , select 'View network status and task'

Step 3: Now select Manage Network Connections.

Step 3: If you are using wireless internet:

Right click on 'Wireless Network Connection' and click on 'Properties'.


If you are using an ethernet/cable connection:

Right click on 'Local Area Connection' and click on 'Properties'.

Step 4: Click on 'Networking' tab, select 'Internet Protocol (TCP/IP)' and click on 'Properties'.

Step 5: Click on 'Use the following DNS server addresses' and enter the DNS server addresses that appeared on your browser earlier.

Step 6: Click OK.

Once you have done that, go back to your Simple Telly's account page and click on Check My Setup.

If this is the first device you have setup from this location, you will probably need to register your current IP address. Click on Register your new IP address.

You will get Everything's OK! message on your screen if your IP has been registered successfully in our system.

Now that you have setup and registered your system you can go ahead and access the TV site of your choice and stream it like you mean it!

If you would like any further assistance, please send us an email to support@simpletelly.com and we will do our best to assist you.

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us